Get Ready for Inspection

Hey Teams,  would you like your robot to be game ready with no surprises at the hardware inspection table?  Here are a few tools for you to make sure your robot is in full compliance on the day of your competition. 

Hardware Inspection: 

 checklist Download the Hardware Inspection Check list.  It's the same that you'll find in the  game manual, conveniently separated.
 box Not sure your robot will fit into that 18" x 18" x 18" sizing box? Here are simple instructions for you to  build a sizing box. 
 flags You'll be sent back to the pit if your robot doesn't have a proper flag holder. To be certain your design will hold a regulation alliance flag securely during competition, here are instructions on  how to make your alliance flags  to the exact regulations.
Bowled Over! Logo 

Don't forget to include a Bill of Materials (BOM) for your robot!  (See your Game Manual Part 2!)

You can get a template on the Game Page or Document Library  

This list MUST be submitted at inspection.

Software Inspection:

 software Download the  Software Inspection Checklist. 

Official templates are required! Don't get sent back to the pit to reconfigure your code because you've not used the proper templates. 

The templates are included with your LabVIEW and ROBOTC software.   

Don't forget to check out the training available for LabVIEW and ROBOTC: Programming Resources
 sam Visit the Samantha Resources  page and the Field Control System page to get training and the most current software.  Practice using the Samantha as much as you can, so you'll be ready to roll when the match begins.